There are several reasons why one would like to connect an old AX.25 Packet-Radio only Transmitter to the DAPNET: * No possibility to change the hardware due to restrictions or motivation * No IP connectivity at the transmitter location * Sentimental reasons to keep the RPC PCB

For thoses cases we provide two possible solutions:

If you setup contains a Packet-Radio connection that is reachable via IGATE, this is the easiest way to get your transmitter migrated from FunkrufMaster to DAPNET.

Just do the following steps:

1. Add db0sda-12 as master to your RPC and store it permanently.
2. Write an email to suppport@hampager.de and give the following information
   1. The transmitter callsign
   2. The AX.25 connect path to reach you RPC via IGATE
   3. The desired timeslots you want to use
   4. The geografical location in decimal form, e.g. N50.123456 E006.123456
   5. The antenna gain minus the cable losses in dBi
   6. The output power in Watt
   7. the antenna height above ground (not NN!)

The DAPNET team will check you request and provide a software solution with dapnet-proxy to connect your transmitter to the network.

TBC