Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste Überarbeitung Beide Seiten der Revision | ||
primodescription [2019/03/19 11:30] oe7bsh [Primo] autOmatically typo |
primodescription [2020/01/21 15:40] df2et [Reading programmed RICs] |
||
---|---|---|---|
Zeile 54: | Zeile 54: | ||
===== RIC programming ===== | ===== RIC programming ===== | ||
- | The Primo pagers obviously share some similarities with Skypers. There is a connector for external programming which probably is the same as found on Skypers. This needs further investigation. | + | The Primo pagers obviously share some similarities with Skypers. |
+ | ==== Reading programmed RICs ==== | ||
+ | If you just want to know which RIC(s) are programmed in your Primo pager there is a special key combination that was deteced by DK7DB. Turn the pager off and press "M" twice. It will show the programmed RICs 1 to 3. | ||
+ | |||
+ | |||
+ | {{ :primo:primo_reading_ric_manually.jpg?600 |}} | ||
+ | |||
+ | ==== Hardware ==== | ||
+ | |||
+ | The connector on the display PCB is identical to the [[skyperdescription#hardware|interface found on Skypers]]. The connector looks as follows: | ||
+ | |||
+ | {{ :primo:primo_progger_interface.jpg?direct&600 | Primo programming interface }} | ||
+ | |||
+ | ==== Software ==== | ||
+ | |||
+ | Using the same programmer as for Skypers ([[skyperdescription#hardware|linked here]]) you read at least read the RIC from the pager. After starting the software you have to load the correct .ROM file. In this case we used 20bd-a.rom and after pressing F1 to read the pager the correct RIC was displayed. | ||
+ | |||
+ | {{ :primo:primo_reading_ric.jpg?direct&600 | Successfully read the RIC off a Primo pager }} | ||
+ | |||
+ | Wrting the pager has not been tested as we are not sure if the .rom file is 100% correct yet. |