Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste Überarbeitung Beide Seiten der Revision | ||
skyperdescription [2018/10/10 11:54] df2et [Re-aligning the RF components] |
skyperdescription [2019/04/16 16:47] oe7bsh [Removing the display from the PCB] |
||
---|---|---|---|
Zeile 63: | Zeile 63: | ||
You need an interface that supplies 3v0 to the pager to activate its programming mode. A small SMD PCB that fits into a DB9 connector case is described here: https://github.com/dk4pa/SKYPER_PROGRAMMER. Power is drawn from a USB port and converted to 3v0. A small amount of PCBs is available at cost from the authors. Please contact DK4PA or DF2ET. The Skyper has a programming interface which is located inside the battery compartment. It requires the wiring of GND, 3v0 as well as RX/TX lines. All experiments to build some sort of plug failed so far. Thus we normally solder the 4 wires to the pads after opening the case. | You need an interface that supplies 3v0 to the pager to activate its programming mode. A small SMD PCB that fits into a DB9 connector case is described here: https://github.com/dk4pa/SKYPER_PROGRAMMER. Power is drawn from a USB port and converted to 3v0. A small amount of PCBs is available at cost from the authors. Please contact DK4PA or DF2ET. The Skyper has a programming interface which is located inside the battery compartment. It requires the wiring of GND, 3v0 as well as RX/TX lines. All experiments to build some sort of plug failed so far. Thus we normally solder the 4 wires to the pads after opening the case. | ||
- | {{ :skyper:skyper_prog.jpg?direct&600 |}} | + | {{ :skyper:skyper_prog.jpg?direct&600 | Skyper Programmer }} |
+ | The connection between programming interface mentioned above and Skyper are as follows: | ||
+ | |||
+ | {{ :skyper:skyper_progger_connection.jpg?direct&600 | Connection of progammer and Skyper }} | ||
==== Software ==== | ==== Software ==== | ||
Zeile 72: | Zeile 75: | ||
{{ :skyper:upgrom.jpg?direct&600 |}} | {{ :skyper:upgrom.jpg?direct&600 |}} | ||
+ | |||
+ | ==== Removing the display from the PCB ==== | ||
+ | |||
+ | lorem ipsum | ||
+ | |||
+ | |||
+ | {{ :skyper:skyperoeffen0.jpg?400 |}} | ||
+ | {{ :skyper:skyperoeffen1.jpg?400 |}} | ||
+ | |||
+ | {{ :skyper:skyperoeffen2.jpg?400 |}} | ||
+ | |||
+ | {{ :skyper:skyperoeffen3.jpg?400 |}} | ||
+ | {{ :skyper:skyperoeffen4.jpg?400 |}} | ||
+ |