Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- skyperdescription [2018/10/10 11:54]
df2et [Re-aligning the RF components]
+++ skyperdescription [2019/04/16 16:53]
oe7bsh [Removing the display from the case]
@@ Zeile 63: / Zeile 63: @@
 You need an interface that supplies 3v0 to the pager to activate its programming mode. A small SMD PCB that fits into a DB9 connector case is described here: https://github.com/dk4pa/SKYPER_PROGRAMMER. Power is drawn from a USB port and converted to 3v0. A small amount of PCBs is available at cost from the authors. Please contact DK4PA or DF2ET. The Skyper has a programming interface which is located inside the battery compartment. It requires the wiring of GND, 3v0 as well as RX/TX lines. All experiments to build some sort of plug failed so far. Thus we normally solder the 4 wires to the pads after opening the case.
-{{ :skyper:skyper_prog.jpg?direct&600 |}}
+{{ :skyper:skyper_prog.jpg?direct&600 | Skyper Programmer }}
+The connection between programming interface mentioned above and Skyper are as follows:
+{{ :skyper:skyper_progger_connection.jpg?direct&600 | Connection of progammer and Skyper }}
 ==== Software ====
@@ Zeile 72: / Zeile 75: @@
 {{ :skyper:upgrom.jpg?direct&600 |}}
+===== Removing the display from the case =====
+The display is mounted in the case with clips. You can use a small screwdriver to *carefully* pull away the case from the display and lift the display (each side after each other)
+{{ :skyper:skyperoeffen0.jpg?400 |}}
+{{ :skyper:skyperoeffen1.jpg?400 |}}
+{{ :skyper:skyperoeffen2.jpg?400 |}}
+{{ :skyper:skyperoeffen3.jpg?400 |}}
+{{ :skyper:skyperoeffen4.jpg?400 |}}
+Photos courtesy DK7TD

DAPNET DokuWiki

Benutzer-Werkzeuge

Webseiten-Werkzeuge

Unterschiede

Seiten-Werkzeuge