Benutzer-Werkzeuge

Webseiten-Werkzeuge


skyperdescription

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen Revision Vorhergehende Überarbeitung
Nächste Überarbeitung
Vorhergehende Überarbeitung
Nächste Überarbeitung Beide Seiten der Revision
skyperdescription [2019/04/16 16:51]
oe7bsh
skyperdescription [2019/06/16 19:00]
dg5ffn
Zeile 76: Zeile 76:
 {{ :​skyper:​upgrom.jpg?​direct&​600 |}} {{ :​skyper:​upgrom.jpg?​direct&​600 |}}
  
-==== Removing the display from the case====+===== Removing the display from the case =====
  
 The display is mounted in the case with clips. You can use a small screwdriver to *carefully* pull away the case from the display and lift the display (each side after each other) The display is mounted in the case with clips. You can use a small screwdriver to *carefully* pull away the case from the display and lift the display (each side after each other)
Zeile 89: Zeile 89:
 {{ :​skyper:​skyperoeffen4.jpg?​400 |}} {{ :​skyper:​skyperoeffen4.jpg?​400 |}}
  
 +Photos courtesy DK7TD
 +
 +
 +
 +===== Preset of display contrast =====
 +
 +Have you ever asked yourself what this tiny trimpot on the rear side of the display board does?
 +
 +Well if your display is working fine and contrast setting can be done via setup menu there is 
 +probably no need to.
 +
 +The initial setting was done by the manufacturer and normally this should work all right.
 +
 +In case you have trouble with your display contrast it may be helpful to check this alignment according to the picture shown below.
 +
 +Turning this trimpot clockwise will increase display contrast while turning counterclockwise will decrease it.
 +Please be aware that this is a very coarse setting. This SMD-trimpot has no upper or lower limitations. It can be turned around the full 360 deg.
 +
 +The fine adjustment is done afterwards in the Skyper setup menu using the up and down keys.
 +
 +
 +{{:​p4240071.jpg|}}
 +
 +
 +===== Separating the display board from the case =====
 +
 +In case you have trouble with the silicone rubber keyboard or with the microswitches underneath
 +you may want to take display board and case of your Skyper apart.
 +Another reason to do this may be that you want to clean the display and case from the inside.
 +
 +
 +{{:​p6160003y.jpg|}}
 +
 +Of course you can do this like DK7TD describes it using a small screwdriver.
 +
 +
 +{{:​p6160026y.jpg|}}
 +
 +
 +
 +{{:​p6160081z.jpg|}}
 +
 +
 +
 +{{:​p6160091y.jpg|}}
 +
 +
 +
 +{{:​p6160079y.jpg|}}
 +
 +
 +
 +{{:​smd_kurzhub_mikroschalter.jpg|}}
skyperdescription.txt · Zuletzt geändert: 2023/05/08 20:58 von dj7lc