Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste Überarbeitung Beide Seiten der Revision | ||
skyperdescription [2019/04/24 18:59] dg5ffn [Preset of display contrast] |
skyperdescription [2019/06/16 19:50] dg5ffn |
||
---|---|---|---|
Zeile 111: | Zeile 111: | ||
{{:p4240071.jpg|}} | {{:p4240071.jpg|}} | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ===== Separating the display board from the case ===== | ||
+ | |||
+ | In case you have trouble with the silicone rubber keyboard or with the microswitches underneath | ||
+ | you may want to take display board and case of your Skyper apart. | ||
+ | |||
+ | Another reason to do this may be that you want to clean the display and case from the inside. | ||
+ | |||
+ | |||
+ | {{:p6160003y.jpg|}} | ||
+ | |||
+ | Of course you can do this the way DK7TD describes it using a small screwdriver. | ||
+ | |||
+ | If you are unlucky you may end up with a display where some lines of pixels are missing | ||
+ | when you power up your Skyper afterwards. | ||
+ | |||
+ | What has happened? While pulling out the display board this way the flexible board connector | ||
+ | atop of the LCD display may move and some pins can get loose. | ||
+ | |||
+ | Should this ever happen there is no way to fix this. | ||
+ | |||
+ | |||
+ | |||
+ | {{:p6160026y.jpg|}} | ||
+ | |||
+ | After experiencing this twice up to now (I have modified >20 Skyper) I asked myself: | ||
+ | |||
+ | Is there a safer way to work on the display board? | ||
+ | |||
+ | YES there is one. | ||
+ | |||
+ | You can fix the LCD to the display board applying a few drops of 2K glue at the positions | ||
+ | shown below. | ||
+ | |||
+ | After hardening for some hours you can pull out the board using a simple smartphone | ||
+ | opening tool at the two shown positions. | ||
+ | |||
+ | One tool is enough - you don't need two of them. | ||
+ | |||
+ | |||
+ | |||
+ | {{:p6160081z.jpg|}} | ||
+ | |||
+ | |||
+ | |||
+ | {{:p6160091y.jpg|}} | ||
+ | |||
+ | If you did the soldering and the modification on the RF board of your Skyper yourself | ||
+ | it should be no problem for you to get the old microswitches out and new ones in. | ||
+ | |||
+ | For me it was difficult to get them here in Germany. The dimensions are listed below. | ||
+ | |||
+ | I found them on eBay. They are quite inexpensive even if you have to order 100 pcs. | ||
+ | |||
+ | In my opinion its a good idea to replace all 4 microswitches even if only one | ||
+ | is faulty. So the look and feel is the same on all 4 keys afterwards. | ||
+ | |||
+ | {{:p6160079y.jpg|}} | ||
+ | |||
+ | |||
+ | |||
+ | {{:smd_kurzhub_mikroschalter.jpg|}} |