Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste Überarbeitung Beide Seiten der Revision | ||
skyperdescription [2019/06/16 20:08] dg5ffn |
skyperdescription [2019/09/27 20:58] dg1kmm Klarer formuliert |
||
---|---|---|---|
Zeile 3: | Zeile 3: | ||
{{::skyper:skyper2.jpg?direct&400 |}} | {{::skyper:skyper2.jpg?direct&400 |}} | ||
- | These pagers normally come with a (more or less) hard-coded RIC. It can be found on a small label on the back side. It is not! the "Skyper Nr." but the second part of the "ID Nr.". It is contains 7 digits of which the last four are underlined (has been used as a PIN in the former life of those units). | + | These pagers normally come with a (more or less) hard-coded RIC. It can be found on a small label on the rear side. It is __not__ the "Skyper Nr." but the second part of the "ID Nr." and consists of seven digits of which the last four are underlined (have been used as a PIN in the commercial Skyper service). |
- | These units support automatic time synchronisation to the DAPNET transmitter/core and rubric messages. The latter need an activation which can be sent out from the hampager portal (See "rubrics"). The rubrics abonnement is apparently lost if the battery dies. | + | These units support automatic time synchronisation to the DAPNET transmitter/core as well as rubrics messages. The latter need an activation which can be sent out from the hampager portal (see "rubrics"); the activation is stored in non-volatile memory. |
+ | The rubrics list, the rubrics contents and your individual rubrics subscription however are stored in SRAM and are lost if your battery runs out of power. If this happens, don't worry - the rubrics list is periodically transmitted by the DAPNET core. Just wait until the Skyper has received the list (this may take several hours) and you are able to subscribe to the rubrics again. If you want to avoid this, be sure to replace a weak battery in time. | ||
+ | |||
+ | ==== Skyper versions ==== | ||
+ | There are various versions of Skypers (e.g. Skyper 1, Skyper 2, Skyper 2/A...). The hardware is identical, but they have different firmware features (and bugs...). For example, the Skyper 2 and up versions have auto-repeat/scrolling in the rubrics list and automatic time resynchronization every Sunday morning. They also turn on automatically after inserting a new battery - the Skyper 1 must be turned on by holding the "M" key. There are a lot more differences between the firmware versions, which are related to closed user groups, overwriting messages etc... DAPNET currently does not use these features, so all Skyper versions are suitable. The hardware modification procedure is always the same. | ||
===== Modification for UHF ham band use ===== | ===== Modification for UHF ham band use ===== | ||
Zeile 117: | Zeile 121: | ||
===== Separating the display board from the case ===== | ===== Separating the display board from the case ===== | ||
- | In case you have trouble with the silicone rubber keyboard or with the microswitches underneath | + | Should you have trouble with the silicone rubber keyboard or with the microswitches underneath |
you may want to take display board and case of your Skyper apart. | you may want to take display board and case of your Skyper apart. | ||
- | Another reason to do this may be that you want to clean the display and case from the inside. | + | Another reason to do this may be that you want to clean the display and case from the inside |
+ | or to replace a damaged Skyper case with a better one. | ||
{{:p6160003y.jpg|}} | {{:p6160003y.jpg|}} | ||
- | Of course you can do this the way DK7TD describes it using a small screwdriver. | + | One straightforward way to do this is the one DK7TD describes using a small screwdriver. |
+ | For an experienced user who knows what he's doing this can be the way to go. | ||
+ | But there is some risk in it especially if you are doing this for the first time. | ||
If you are unlucky you may end up with a display where some lines of pixels are missing | If you are unlucky you may end up with a display where some lines of pixels are missing | ||
Zeile 135: | Zeile 142: | ||
atop of the LCD display may move and some pins can get loose. | atop of the LCD display may move and some pins can get loose. | ||
- | Should this ever happen there is no known way to fix this. | + | Should this ever happen there is no known way to fix it. |