====== DAPNET Transceiver with Motorola GM360 ======

===== Introduction =====

What is needed for the usage of a Motorola GM360 transceiver

  * Motorola GM360 UHF
  * Raspberry Pi (no matter what model, How-To is based on a RPi 3B+)
  * An original Motorola accessory connector. Alternatively a 20 or 16 pin Dupont connector
  * A 3.5mm stereo jack plug
  * A 22 uF capacitor
  * A generic NPN transistor (i.e. BC547)
  * A 470 ohm resistor


{{ :g360_ras_pocsag.jpg?nolink&800 |}}

  * Motorola pin 3 is the PTT wire (pulled to GND in case of transmission)
  * Motorola pin 5 is the audio signal
  * Motorola pin 7 is GND

===== Miscellaneous settings =====

  * Alsamixer, audio volume 100
  * Unipager audio level 42
  * Unipager 'Inverted' checked
  * Unipager TX delay 15


Thanks to Lutz dh7lk for this contribution