Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- ft8500 [2020/02/18 10:12]
df2et
+++ ft8500 [2020/02/18 10:21]
df2et
@@ Zeile 26: / Zeile 26: @@
 {{:sdrpager:ft8500_bottom.png?400|}}
+An old used ethernet cable can be used to connect the PCB to the transmitter. One off the RJ45 plugs is to be cut off and replaced by the miniDIN connector. The left most 3 pins of the RJ45 connector are used (see photo). In this case the wires have the colors green/white, green and orange/white. In case you are unsure use an ohm-meter to determine pin numbers.
+{{:sdrpager:ft8500_rj45.png?400|}}
+  * Pin 1 is the PTT wire (pulled to GND in case of transmission)
+  * Pin 2 is the audio signal
+  * Pin 3 is GND
+These wires need to be connected to the FT-8500 as follows. The image shows the jack (female connector) of the FT-8500.
+{{:sdrpager:ft8500_minidin.png?400|}}
+Connections for the FT-8500
+  * RJ45 pin 1 to miniDIN pin 3
+  * RJ45 pin 2 to miniDIN pin 1
+  * RJ45 pin 3 to miniDIN pin 2
+===== UniPager Configuration =====
+For installation see [[unipager|UniPager]].
+Settings for the FT-8500:
+  * Set alsamixer output to 100%
+  * Audio level in UniPager set to 56 and tick checkbox "inverted"
+  * PTT GPIO pin 0 (not inverted)

DAPNET DokuWiki