Benutzer-Werkzeuge
raspagerc9000
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Letzte Überarbeitung Beide Seiten der Revision | ||
|
raspagerc9000 [2018/10/10 09:49] df2et [Software and Software issues] |
raspagerc9000 [2018/10/10 10:00] df2et [Front Panel LEDs] |
||
|---|---|---|---|
| Zeile 156: | Zeile 156: | ||
| * Pin 6: SWAct | * Pin 6: SWAct | ||
| * Pin 7: MasterConn | * Pin 7: MasterConn | ||
| + | |||
| + | {{ :c9000:c9000leds.png?nolink&600 | Pinout for Fron Panel LEDs}} | ||
| These LEDs indicate if UniPager is connected to the Master (MasterConn) and when its active (SWAct). The corresponding LEDs are not controlled by UniPager directly. You have to use the extra python script called unipagerled.py. It is sufficient to use the preset from the example in the config (/etc/unipagerledconfig.py): | These LEDs indicate if UniPager is connected to the Master (MasterConn) and when its active (SWAct). The corresponding LEDs are not controlled by UniPager directly. You have to use the extra python script called unipagerled.py. It is sufficient to use the preset from the example in the config (/etc/unipagerledconfig.py): | ||
| Zeile 162: | Zeile 164: | ||
| Two resistors (330R) are already present on the PCB (see R10 and R11). The two LEDs can be mounted on the fron panel of the Base Station Controller. | Two resistors (330R) are already present on the PCB (see R10 and R11). The two LEDs can be mounted on the fron panel of the Base Station Controller. | ||
| + | |||
| + | {{ :c9000:c9000frontpanelleds.jpg?nolink&600 | Front Panel LEDs}} | ||
| ==== Temperature Monitoring ==== | ==== Temperature Monitoring ==== | ||
| The RasPagerC9000 PCB is already prepared for easy implementation of a temperature monitoring of the C9000. It is done by cheap DS18x20 OneWire temperature sensors. In order to activate the built-in support for OneWire temperature sensors in the Raspbian software, add the following line tho ''/boot/config.txt'' | The RasPagerC9000 PCB is already prepared for easy implementation of a temperature monitoring of the C9000. It is done by cheap DS18x20 OneWire temperature sensors. In order to activate the built-in support for OneWire temperature sensors in the Raspbian software, add the following line tho ''/boot/config.txt'' | ||
raspagerc9000.txt · Zuletzt geändert: 2019/07/16 23:24 von df2et
Seiten-Werkzeuge
Falls nicht anders bezeichnet, ist der Inhalt dieses Wikis unter der folgenden Lizenz veröffentlicht: CC Attribution-Share Alike 4.0 International
