Benutzer-Werkzeuge

Webseiten-Werkzeuge


raspagerc9000

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen Revision Vorhergehende Überarbeitung
Nächste Überarbeitung
Vorhergehende Überarbeitung
raspagerc9000 [2018/10/10 09:49]
df2et [Software and Software issues]
raspagerc9000 [2019/07/16 23:24] (aktuell)
df2et
Zeile 156: Zeile 156:
   * Pin 6: SWAct   * Pin 6: SWAct
   * Pin 7: MasterConn   * Pin 7: MasterConn
 +
 +{{ :​c9000:​c9000leds.png?​nolink&​600 | Pinout for Fron Panel LEDs}}
  
 These LEDs indicate if UniPager is connected to the Master (MasterConn) and when its active (SWAct). The corresponding LEDs are not controlled by UniPager directly. You have to use the extra python script called unipagerled.py. It is sufficient to use the preset from the example in the config (/​etc/​unipagerledconfig.py):​ These LEDs indicate if UniPager is connected to the Master (MasterConn) and when its active (SWAct). The corresponding LEDs are not controlled by UniPager directly. You have to use the extra python script called unipagerled.py. It is sufficient to use the preset from the example in the config (/​etc/​unipagerledconfig.py):​
Zeile 162: Zeile 164:
  
 Two resistors (330R) are already present on the PCB (see R10 and R11). The two LEDs can be mounted on the fron panel of the Base Station Controller. Two resistors (330R) are already present on the PCB (see R10 and R11). The two LEDs can be mounted on the fron panel of the Base Station Controller.
 +
 +{{ :​c9000:​c9000frontpanelleds.jpg?​nolink&​600 | Front Panel LEDs}}
 ==== Temperature Monitoring ==== ==== Temperature Monitoring ====
 The RasPagerC9000 PCB is already prepared for easy implementation of a temperature monitoring of the C9000. It is done by cheap DS18x20 OneWire temperature sensors. In order to activate the built-in support for OneWire temperature sensors in the Raspbian software, add the following line tho ''/​boot/​config.txt''​ The RasPagerC9000 PCB is already prepared for easy implementation of a temperature monitoring of the C9000. It is done by cheap DS18x20 OneWire temperature sensors. In order to activate the built-in support for OneWire temperature sensors in the Raspbian software, add the following line tho ''/​boot/​config.txt''​
Zeile 616: Zeile 620:
 https://​github.com/​phl0/​C9000PADummyDisplay https://​github.com/​phl0/​C9000PADummyDisplay
  
-The author has some PCBs to sell at cose. Please contact DF2ET if you are interested.+The author has some PCBs to sell at cost. Please contact DF2ET if you are interested.
  
 The 7-segement display is supported by the C9000PADummy Arduino code. To activate it you have to compile the code with  The 7-segement display is supported by the C9000PADummy Arduino code. To activate it you have to compile the code with 
raspagerc9000.1539157798.txt.gz · Zuletzt geändert: 2018/10/10 09:49 von df2et