Benutzer-Werkzeuge
ax25
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung | ||
|
ax25 [2018/01/08 13:10] dh3wr |
ax25 [2018/02/27 11:08] (aktuell) dh3wr [Connecting old Packet-Radio only transmitters via AX.25] |
||
|---|---|---|---|
| Zeile 1: | Zeile 1: | ||
| ====== Connecting old Packet-Radio only transmitters via AX.25 ====== | ====== Connecting old Packet-Radio only transmitters via AX.25 ====== | ||
| - | There are several reasons why one would like to connect an old AX.25 Packet-Radio only Transmitter to the DAPNET: * No possibility to change the hardware due to restrictions or motivation | + | There are several reasons why one would like to connect an old AX.25 Packet-Radio only Transmitter to the DAPNET: |
| - | * No IP connectivity at the transmitter location | + | * No possibility to change the hardware due to restrictions or motivation |
| - | * Sentimental reasons to keep the RPC PCB :-) | + | * No IP connectivity at the transmitter location |
| + | * Sentimental reasons to keep the RPC PCB :-) | ||
| For thoses cases we provide two possible solutions: | For thoses cases we provide two possible solutions: | ||
| Zeile 29: | Zeile 30: | ||
| - Connect your RPC card by means of a USB-2-Serial converter | - Connect your RPC card by means of a USB-2-Serial converter | ||
| - | - Setup the ax0 kernel network device with kissattach | + | - Setup the ax0 kernel network device with kissattach. Edit ///etc/ax25/axport// before. |
| - Install xinetd | - Install xinetd | ||
| - Add the file below to a file in ///etc/xinetd.d// | - Add the file below to a file in ///etc/xinetd.d// | ||
| Zeile 50: | Zeile 51: | ||
| server_args = -r -S -R -s db0sda-12 -r ax0 db0sda-7 | server_args = -r -S -R -s db0sda-12 -r ax0 db0sda-7 | ||
| } | } | ||
| - | <file> | + | </file> |
| In this example //db0sda-12// is the defined master callsign in your RPC card and //ax0// is the AX.25 kernel-interface you created with //kissattach// and //db0sda-7// is the AX.25 connect path incl. the destination callsign (most probably only your RPC callsign). | In this example //db0sda-12// is the defined master callsign in your RPC card and //ax0// is the AX.25 kernel-interface you created with //kissattach// and //db0sda-7// is the AX.25 connect path incl. the destination callsign (most probably only your RPC callsign). | ||
| - | Further information on the DAPNET-Proxy is here. | + | Further information on the [[dapnetproxy|DAPNET-Proxy]] is [[dapnetproxy|here]]. |
ax25.1515413454.txt.gz · Zuletzt geändert: 2018/01/08 13:10 von dh3wr
Seiten-Werkzeuge
Falls nicht anders bezeichnet, ist der Inhalt dieses Wikis unter der folgenden Lizenz veröffentlicht: CC Attribution-Share Alike 4.0 International
